Hyundai iLoad and iMax TQ
Browse by Date
0281012704 0281012875 0281013055 0281016312 0281016316 0281019357 abs abs warning light automotive electronic repair solutions bcm bk bl body control module clusters cruze jg cruze jh dash ecms electronic steering lock engine esl fault forced throttle shut down ford falcon ba ford falcon fg ford falcon fg icc ford ranger ford ranger / mazda bt50 - no left hand side low beam ford territory sx series him modules - test & repair service holden commodore ve holden cruze holden cruze jg series holden ve / vf series tehcm hybrid abs repair solutions hydraulic brake booster hyundai iload and imax tq information display installing instrument cluster interior command centre l34n189e l552189e lancer cj lexus lfae189e lfjs189e mazda 3 mazda bt50 mercedes benz w204 mitsibishi pajero mitsubishi lancer mitsubishi outlander / pajero no start programming repair service statesman wm stop lights stop lights not working territory sz toyota landcruiser abs transmission control module water damaged ecm
Hyundai iLoad and iMax TQ
HYUNDAI: NO START, NO COMMUNICATION WITH A SCAN TOOL, CUTTING OUT UPON ACCELERATION
Model: iLoad and iMax TQ series D4CB 2.5L Diesel (2008-onwards)
Injectronics have received a great deal of feedback from our customers that the Hyundai iLoad and iMax vehicles have been presenting to workshops with a no start fault. Technicians have also been unable to communicate with the vehicle’s ECM (Engine Control Module) using a Scan-tool. The number of ECM’s Injectronics are receiving with fault code P0605 (Internal Control Module Read Only Memory ROM Error) has been steadily increasing.
The ECM continuously monitors its own internal memory status, internal circuits and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning correctly. If any malfunction is detected, the ECM sets this P0605 fault code.
Injectronics are now able to bench test and repair customers own Bosch EDC16C39-5.41 ECM’s for the above specified faults, and also carry replacement units which can be programmed by Injectronics to the vehicles security system and specific variants. This allows the ECM to then be “plug n play”, saving time and further costs.
In order for Injectronics to test or repair these units we also require the Key, Key Reader & Immobiliser module as shown above. When a Technician is presented with this scenario possible symptoms include:
- Vehicle cranks but will not fire
- No check engine light & no dash lights illuminated in the instrument cluster
- Vehicle cutting out upon acceleration
- Possible causes:
- Engine Control Module (ECM) may be faulty
- ECM harness power supply circuit is open or shorted
- ECM harness ground circuit is open or shorted